Contact Us
TEL: +86-576-83010721
Mob: +8613282666918
E-mail: cici@zolay.com
Address: 420, Xidong, Tiantai, Zhejiang, China
Home > Knowledge > Content
Rubber conveyor belt replacement method
Mar 17, 2018

How to replace a damaged rubber conveyor belt:

1. Pull the tension on the belt conveying machine, such as the circular EP rubber band, and pull it tightly together with the tensioning device. Mark the chamfered edges in the middle of the two tensioning devices and cut off the EP conveyor belt.

2. Cut the replaced body section parallel to the chamfered side. Note that the body must be supported on the shelf in advance;

3. Calculate the lap length of the layered conveyor belt: the length of the front and rear joints *2 + the length of the replaced section + the width of the EP rubber band * 0.3 times the oblique section.


Previous: What material is the conveyor belt usually made of?

Next: No Information